Disclaimer: Use it on your own risk. Make sure that bad flashing can destroy your drive completly. ALL FLASHINGS ARE A RISK FOR THE DRIVE!
Patches based on XVI's patch for CyberDrive DM126D 1x3C.
|Ultima Flashtool 1.0.1||DOS||I sugest this to flash your Artec/Ultima drive|
|Ultima Flashtool 1.0.6||DOS||Work with 3.xx, The firmware name must be vn*.bin (n=1,2,3 ...) rename the firmware first.|
|OPDCTEST||DOS||Use only +/- to select the drive and "F" to flash. I think you can edit many parameters here.|
|FLDL||DOS||Flashtool from Cyberdrive|
|DRIVE||RPC2 (original)||RPC1 (free)||Remarks|
|ARTEC/ULTIMA 16x DHI-G40 1.xx|
IDE DVD-ROM 16x 1.xx
Warning! Don't try 2.xx or 3.xx firmwares!
|ARTEC/ULTIMA 16x DHI-G40 2.xx||2.01||2e01||Untested! uFlash 1.0.1 and opdctest doesnt work with this drive
Warning! Don't try 1.xx or 3.xx firmwares!
|ARTEC/ULTIMA 16x DHI-G40 3.xx||
|uFlash 1.0.1 and opdctest doesnt work with this drive
Warning! This is not usable for older drives and cannot flashed back!
|ARTEC/ULTIMA 16x DHM-G48 and DHM-G48R||This drive has an MediaTek chipset|
|AGI 16X DVD-ROM||1.08||1p08||This files came from Cyberdrive website DM166D 108B but it was removed now.|
If this drive goes to high speed after flashing (no reading) please flash AGI 1p08 and the the 8x Cyberdrive firmware from the firmware page.Buggy Hardware?
Patch by XVI
I suggest to use this firmware
|Cyberdrive DM166D||100B||1E0B||Cyberdrive DM168D||This drive has an MediaTek chipset|
uFlash 1.0.1 and opdctest may not work with this drive
Warning! Don't Mix 1.xx and 2.xx
|CXD 1822 PLAYER 1.xx||-||1.7B||This is a 2x limited firmware from a Consumer Player. This should work on all drives on this page with firmware lower than 2.00|
Flashing your drive! (Works only with real DOS-MODE)
Create a Bootdisk and unzip Ultima Flasher and a firmware to the root directory of the bootdisk.
Boot the system from the disk and run uFlash
Type the name of the Firmware (with .bin).
The drive will now flashed.
If the flash ended you can reboot the system with new firmware.
If the drive not answer within 10 seconds the flashing was failed and the drive is dead! It can only recovered by desoldering the flash and reprogram it outside of the drive. (very Expensive tools needed).
If you have other Firmwares please mail me.